Bix stripper professional#

A working temperature of 65 to 85 degrees is usually recommended. Strippers work best in warm temperatures. No-wash strippers are also sold with these, residue can be cleaned from the surface with rags and steel wool. Homer Formby, a manufacturer of finishes and strippers, says water-rinse strippers should not be used on any type of wood furniture, because the water can weaken glued joints or otherwise harm the wood.Ī better choice for fine wood are strippers that clean up with solvents, such as mineral spirits (paint thinner). Water-rinse strippers should not be used on veneered surfaces.

Water-rinse strippers are the best choice when paint is being removed from bricks or other masonry, metal and some wood surfaces. Some strippers can be washed off with water, making it easier to rinse stripper sludge from convoluted or porous surfaces. Semi-paste strippers cling well to vertical surfaces and are best for all-around stripping. The liquid is usually less expensive, but is most useful on horizontal surfaces such as table tops or doors laid flat. Strippers are sold in both liquid and semi-paste form. Urethane finishes might require a high-strength product, such as Savogran’s Super-Strip or Bix Stripper. Typical strippers will remove oil-based and latex paint, enamel, varnish, lacquer and shellac. Even alternative removal methods - such as heat, scraping or sanding - are dangerous with lead paint, because vapors or particles of lead can be released into the air of the home. Removal of woodwork for outside stripping also should be considered if there is any possibility that the paint is the old, lead-based type.

Bix stripper professional#

In some cases, such as stripping indoor trim or cabinets, the woodwork can be removed and either stripped outdoors or taken to a professional stripping service. When I begin to imagine molds, layup, different factories, different raw materials, different suppliers, it's no wonder frames are so schizophrenic.When paint must be stripped indoors, consider alternate methods such as a heat gun, a remover that does not contain methylene chloride, or use sanding or scraping to remove the paint. This process has enlightened me to how sensitive the racquet recipe is to its ingredients. The n90, to me at least, has a weird balance, so maybe this change will turn out to be a good thing. Feels just the opposite flexier in the throat now, like there is more weight on the ends and less in the middle. The weird part is it doesn't feel/swing that way. That would suggest that more paint collected on the lower part of the racquet. Went from 8 to 9 pts head light, but the static weight is the still the same. Makes perfect sense now that I think about it - there is almost an ounce of mass in the paint, and depending on how evenly or unevenly it's applied, it can really alter the balance and feel. I was very careful with the static weight, weighing between each coat, but I didn't think to keep an objective eye on the balance. The biggest difference is the balance has changed. With the n90, that is probably not such a bad thing. I haven't played any matches with it yet, but hit some serves and groundstrokes against a wall.įirst thing I noticed is that it sounds different a little brighter, less muted and more raw.